Water overflowing the gutter during rain
We clear clogs, re-pitch the run, and check that downspouts are sized correctly. If the gutter is undersized for your roof area, we can upsize it.
When your gutters fail, water goes where it shouldn't: into your fascia boards, behind your siding, and down your foundation. We handle gutter repair Conroe TX homeowners call us for because we've seen what one clogged downspout can do after a hard Texas rain. Our team fixes leaks, re-secures loose runs, and replaces damaged sections so your roofline drains the way it should.
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now (936) 305-7093 → No spam. No obligation. Just practical help.
Gutter repair Conroe TX is the process of restoring damaged, leaking, or loose rain gutters so they channel water away from your roof and foundation again. It's not just patching a hole. We inspect the full run, check hangers and spikes, reseal seams, re-pitch sections that have pulled away from the fascia, and clear downspouts that have clogged with shingle grit and pine needles. If a section is too far gone, we replace it with seamless aluminum matched to your existing profile.
In Conroe, gutters take a beating. Summer UV bakes the sealant, winter freezes crack seams, and spring storms dump two inches of rain in an hour. That's why we see so many calls for gutter leak repair Conroe TX after a heavy weather week. If you've noticed water sheeting off your roof edge or pooling near your slab, the problem is usually a failed seam, a loose hanger, or a downspout that's disconnected underground.
Every gutter repair job is different, but here's what we typically cover. If we find something outside this scope, we'll tell you before we do the work.
We check every run, hanger, seam, and downspout. We use a moisture meter on the fascia and soffit to find hidden rot. You get a clear report of what's failing and why.
Leaking seams are the most common gutter problem. We clean the joint, apply gutter-grade sealant, and test it with water. If the seam is too far gone, we replace that section.
Gutters that sag or back-pitch don't drain. We adjust hangers and re-pitch the run so water flows to the downspout. We use heavy-duty hangers that hold up to Texas heat.
Clogged downspouts cause gutters to overflow. We flush them, reconnect disconnected sections, and repair crushed underground lines if accessible.
If the wood behind the gutter is rotted, we replace it. New fascia boards are primed and sealed before we re-attach the gutter. This prevents the gutter from pulling loose again.
When a gutter section is crushed or rusted through, we fabricate a seamless aluminum replacement on-site. It matches your existing profile and color.
We walk the roofline and check every gutter run, hanger, seam, and downspout. We use a moisture meter on the fascia and soffit boards to find hidden rot. You get a clear explanation of what's failing and why, not a sales pitch.
We give you a flat price before we start. No hourly surprises. If we find something extra, like a rotted fascia section or a crushed underground downspout, we tell you what it costs to fix before we touch it.
We re-pitch sagging runs, replace broken hangers, reseal seams with gutter-grade sealant, and swap out damaged sections with seamless aluminum. Downspouts get cleared and reconnected. We use a caulking gun and pry bar to work clean and avoid damaging your shingles.
Before we pack up, we run water through the gutter and watch it exit the downspout. If it pools or backs up, we adjust the pitch on the spot. You see it drain correctly before we leave.
We haul off old gutter sections, sweep the ground, and walk the job with you. You get a plain-language rundown of what we fixed and what to watch for. If we see a roof issue while we're up there, we point it out.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
We use it to check fascia and soffit boards for hidden moisture behind the gutter. It tells us if wood is sound or starting to rot.
Helps us find water intrusion behind walls and under roof decks that isn't visible to the eye. We use it when we suspect hidden damage.
For applying gutter-grade sealant to seams and joints. We use high-quality sealant that stays flexible in Texas heat.
For carefully removing gutter sections and fascia boards without damaging adjacent materials.
We work safely at height. Our crews are OSHA 10 and OSHA 30 trained.
For inspecting steep or high rooflines and gutter runs that are hard to see from the ground. We use it to document damage.
A 30-foot gutter run was back-pitched, causing water to pool and overflow onto the fascia. The fascia was soft and the gutter was pulling loose.
We replaced two rotted fascia boards, re-pitched the run, and installed new heavy-duty hangers. Water now flows to the downspout. The repair took four hours.
High winds had torn a 20-foot gutter section loose. It was hanging by one hanger and had a large dent. Water was running behind it and soaking the soffit.
We removed the damaged section, replaced it with seamless aluminum, and re-secured it with new hangers. The soffit was dried and sealed. Job took three hours.
A downspout was completely clogged with shingle grit and leaves. Water was backing up and overflowing the gutter, staining the siding.
We flushed the downspout, cleared the debris, and reconnected a loose joint. We also resealed two leaking seams. The gutter now drains freely. Took two hours.
These are the calls we get most often. If you're seeing any of these signs, call us before the damage spreads.
Ask a pro →We clear clogs, re-pitch the run, and check that downspouts are sized correctly. If the gutter is undersized for your roof area, we can upsize it.
We replace failed hangers with heavy-duty ones, re-secure the gutter to solid wood, and replace any rotted fascia we find.
We clean and reseal the seam with gutter-grade sealant. If the metal is cracked, we replace the section with seamless aluminum.
We flush the downspout, clear debris, and reconnect any disconnected sections. If the underground line is crushed, we can reroute it above ground.
“We had water pouring over the gutter every time it rained. Conroe Shield came out, found the run was back-pitched, and fixed it in about two hours. They also cleared a downspout that was completely clogged with pine needles. No more waterfall off the roof. Fair price, no upsell.”
Mark R.Homeowner, River Plantation
✓ Verified“After the last storm, a section of gutter pulled loose and was hanging off the fascia. I called and they were out the next morning. They re-secured it, replaced two hangers, and resealed the seam. You can't even tell it was damaged. I appreciated the same-day estimate.”
Linda T.Homeowner, Panorama Village
✓ Verified“I had a leak at a gutter seam that was dripping right onto my porch. They came out, resealed it, and also showed me where the fascia was starting to rot. Fixed that too. It's been through two heavy rains since and no leaks. Good communication, showed up on time.”
James K.Homeowner, Downtown Conroe
✓ VerifiedMost gutter repairs in Conroe run $150 to $650 depending on scope. A simple reseal or re-pitch is on the low end. Replacing a 20-foot section with seamless aluminum, fixing fascia rot, or reconnecting underground downspouts pushes it higher. We give you a flat price before we start, so there are no surprises.
Yes. Most gutter problems, including leaks, sagging, loose hangers, and clogged downspouts, are repairable. We reseal seams, re-pitch runs, replace damaged sections, and fix the fascia behind them. If the gutter is crushed or the metal is rusted through, we replace that section with seamless aluminum matched to your existing profile.
Conroe Shield Roofing repairs gutters across Conroe and Montgomery County. We're based here, not in Houston, so we know the local building stock and weather patterns. Call (936) 305-7093 and we'll schedule a same-day estimate. We serve Downtown Conroe, River Plantation, Panorama Village, and surrounding areas.
Most gutter repairs take two to four hours. A simple reseal or re-pitch is often under two hours. Replacing a long run with seamless aluminum or repairing fascia rot can take a full day. We'll give you a time window when we schedule and call if anything changes.
Don't wait for the next storm to make that small leak a big problem. Call Conroe Shield Roofing at (936) 305-7093 for a same-day estimate. We'll tell you exactly what's wrong and what it costs to fix.
Call for estimate (936) 305-7093 →Call us at (936) 305-7093 or email info@conroeshieldroofing.com and we will get you scheduled. We answer 24/7 for emergencies and return non-urgent calls the same business day. Free estimates across Conroe and Montgomery County.