We fix leaks, rust, and storm damage on metal panels

Metal Roof Repair in conroe done right the first time

Metal Roof Repair in conroe means finding the leak, securing the panels, and stopping the rust before it spreads. We handle standing seam, corrugated, and R-panel roofs across Montgomery County. If your metal roof is leaking at a fastener or showing rust streaks, we can get it sealed and watertight fast.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

Call Now (936) 305-7093 → No spam. No obligation. Just practical help.
Conroe Shield Roofing — roof repair you can rely on
Careful work. Honest options.
About this service

What Metal Roof Repair in conroe actually involves

Metal Roof Repair in conroe is the process of restoring watertightness and structural integrity to standing seam, corrugated, or R-panel roofing systems. We start with a moisture meter and infrared camera scan to find hidden leaks, then inspect every fastener, seam, and flashing point. From there we replace failed sealant, tighten or replace screws with neoprene washers, treat rust with a rust-inhibiting primer, and re-secure panels that have lifted in high winds. Most repairs take two to four hours and use materials matched to your existing panel profile.

Conroe sits in a hail and wind corridor, and metal roofs here take a beating from spring storms and summer heat that expands and contracts panels daily. We see a lot of metal roof leak repair conroe TX calls after a hailstorm knocks loose fasteners or a wind gust peels back a ridge cap. If you search for metal roof repair near me conroe TX, you want someone who understands how Texas heat cycles stress metal panels and sealants. We have been fixing those exact problems since 2012.

  • ✓ Stop leaks fast
  • ✓ Extend roof life
  • ✓ Prevent rust spread
  • ✓ Protect against storms
What's included

What our metal roof repair service includes

Every metal roof repair job includes a full inspection, a written scope, and a workmanship warranty. Here is what you get when you hire us.

✓

Full roof inspection

We inspect fasteners, seams, flashing, pipe boots, ridge caps, and panel condition. We use a moisture meter and infrared camera to find hidden leaks. You get photos of every issue.

✓

Fastener replacement

We replace missing or backed-out screws with new fasteners that have neoprene washers. We match the screw type to your panel profile so the repair lasts.

✓

Rust treatment and priming

Surface rust gets ground down and treated with a rust-inhibiting primer. We then apply a metal-safe sealant or coating to protect the area from future corrosion.

✓

Seam and flashing resealing

We clean and re-seal seams, ridge caps, and flashing points with roof sealant rated for Texas heat. This stops leaks at the most common entry points.

✓

Panel re-securing

Lifted or loose panels get re-secured to the deck. We check that panels are flat and aligned so they do not oil can or rattle in the wind.

✓

Cleanup and magnet sweep

We clean up all debris and run a magnet sweep over your yard and driveway. You will not find screws or metal shavings in your grass after we leave.

How it works

How our metal roof repair process works

01

Call and schedule

You call (936) 305-7093 or book online. We ask a few questions about the leak, the roof age, and the panel type. Most inspections get scheduled within 24 to 48 hours, and emergency metal roof repair conroe TX calls get same-day attention when we can get there.

02

On-site inspection

A HAAG Certified Inspector walks the roof with a moisture meter and infrared camera. We check fasteners, seams, flashing, pipe boots, and ridge caps. You get photos of every problem area and a written scope before we leave.

03

Repair day

We arrive with materials matched to your panel profile. Repairs typically take two to four hours. We replace failed fasteners, re-seal seams with roof sealant, treat rust, and re-secure any lifted panels. You get a walkthrough when we are done.

04

Testing and cleanup

We run water over the repaired area to confirm the leak is stopped. Then we magnet-sweep the yard for screws and nails. You should not find a single fastener in your grass when we leave.

05

Follow-up

We call you 30 days after the repair to confirm everything is holding. If you see any new leak or issue, we come back. Our workmanship warranty covers the repair for one year from the date of service.

Tools & methods

Tools and methods we use for metal roof repair

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Moisture meter

Detects hidden moisture in the roof deck and insulation so we can find leaks that are not visible on the surface.

Infrared camera

Shows temperature differences that reveal wet areas under the panels, helping us pinpoint leaks without tearing apart the roof.

Roofing nail gun

Used for securing underlayment and flashing when we need to make repairs that involve the roof deck.

Caulking gun

Applies roof sealant evenly along seams and flashing. We use high-grade sealant rated for Texas heat.

Safety harness

Keeps our technicians safe while working on steep metal roofs. We use harnesses on every job, no exceptions.

Magnet sweep

Picks up screws, nails, and metal shavings from your yard after the repair. We do not leave debris behind.

Drone

Provides aerial photos of your roof for documentation and insurance claims. We use drones when safe access is limited.

Real results

Before and after.

Leaking chimney flashing repaired

Before

A homeowner in Bentwater had a leak around the chimney that had stained the ceiling in two rooms. Two other roofers had tried to seal it with caulk, but the leak returned after every rain.

After

We removed the old flashing, cleaned the area, and installed new metal flashing that matched the panel profile. We sealed it with high-grade roof sealant. The leak stopped, and the homeowner was able to repair the ceiling.

Rust treatment on corrugated roof

Before

A Downtown Conroe home had heavy rust along the seams of its corrugated metal roof. The rust was starting to cause pinhole leaks, and the homeowner was worried about replacing the entire roof.

After

We ground down the rust, applied a rust-inhibiting primer, and re-sealed the seams. We also replaced 25 fasteners that were rusted or loose. The roof is now watertight and looks much better.

Storm damage repair after hail

Before

A hailstorm in River Plantation left dents in a metal roof and knocked out several fasteners. The homeowner had a leak in the garage and was worried about further damage.

After

We tarped the roof the same day and returned two days later to replace 40 fasteners and two damaged panels. We documented everything for the insurance claim, which covered most of the cost.

Problems we solve

Metal roof problems we solve in conroe

Metal roofs fail in predictable ways. Here are the most common problems we fix for Conroe homeowners.

Ask a pro →
01

Leaking fasteners and backed-out screws

We replace failed fasteners with new screws and neoprene washers. We also check torque on all nearby fasteners to prevent future backing-out.

↗
02

Rust along seams and panel edges

We grind away rust, apply a rust-inhibiting primer, and seal the area with a metal-safe coating. This stops corrosion and adds years to your panel.

↗
03

Flashing leaks at chimneys and walls

We remove old flashing, clean the area, and install new flashing that matches your panel profile. We seal it with high-grade roof sealant.

↗
04

Wind-lifted panels and ridge caps

We re-secure lifted panels and ridge caps with proper fasteners. If a panel is too damaged, we replace it with a matching panel.

↗
Proof you can check

Licensed, certified, and reviewed

✓
HAAG Certified InspectorHAAG Engineering
✓
NRCA MemberNational Roofing Contractors Association
✓
OSHA 10Occupational Safety and Health Administration
✓
OSHA 30Occupational Safety and Health Administration
✓
Texas Roofing LicenseTexas Department of Licensing and Regulation
Customer reviews

What conroe homeowners say about our metal roof repair

★★★★★
“We had a leak around our chimney flashing that two other roofers could not find. Conroe Shield brought out an infrared camera and found it in 20 minutes. They fixed it the same day and charged exactly what they quoted. No more leak after three hard rains.”
MR

Mark R.Homeowner, Bentwater

✓ Verified
★★★★★
“After the last hailstorm, we had dents and a leak in our corrugated roof. They tarped it the same day we called and came back two days later to do the permanent repair. Insurance covered most of it. Good communication throughout.”
JP

James P.Homeowner, River Plantation

✓ Verified
Good questions

Frequently Asked Questions

(936) 305-7093 →

Most metal roof repairs in Conroe cost between $350 and $1,200 in 2026, depending on the scope. A simple fastener replacement and re-seal runs $350 to $500. Rust treatment and panel repair can run $600 to $1,200. Emergency tarping starts at $250. We give you a written price before we start, so there are no surprises.

Yes. Metal roofs are highly repairable. We fix leaks, replace fasteners, treat rust, re-seal seams, and re-secure panels every day in Conroe. The key is matching the repair materials to your panel profile and using the right sealants for Texas heat. A repaired metal roof can easily last another 10 to 20 years.

Conroe Shield Roofing repairs metal roofs across Montgomery County. We are based in Conroe and serve neighborhoods like Bentwater, April Sound, River Plantation, and Woodforest. Call (936) 305-7093 and we will schedule an inspection, usually within 24 to 48 hours.

Most metal roof repairs take two to four hours. A simple leak fix might take 90 minutes. Rust treatment and panel replacement can take a full day. We schedule a half-day window for most jobs and give you a time range when we confirm your appointment.

Ready when you are

Get your Metal Roof Repair in conroe scheduled today

We answer the phone 24/7 for emergencies. Call (936) 305-7093 and we will schedule your inspection, usually within 24 to 48 hours. You get a written estimate the same day we inspect.

Book Inspection (936) 305-7093 →
Request an appointment

Contact Conroe Shield Roofing

Call us at (936) 305-7093 or email info@conroeshieldroofing.com and we will get you scheduled. We answer 24/7 for emergencies and return non-urgent calls the same business day. Free estimates across Conroe and Montgomery County.

Tap to call(936) 305-7093